Linear DXS-25 transmitter 315mhz

Help, Troubleshooting, and Instructions

Linear Help, Troubleshooting, and Instructions

Linear dxs-25 transmitter

• The Model DXS-25 Supervised 5-Button, 8-Channel Handheld Transmitter is a supervised, digitally coded radio transmitter designed for use with Linear's DX and DXS Format receivers. Pressing a button on the transmitter sends a digitally coded wireless signal to its companion receiver. To send a complete signal, press the transmitter button for a minimum of 2 seconds. The top button can be hidden with the top button cover supplied.
  
  The DXS-25 is a five-button, eight-code transmitter. Pressing any of the transmitter's front buttons sends codes one through four. Holding down the small button on the transmitter's top together with pushing with any of the front buttons sends codes five through eight.
  
  The digital DXS code format features over a million possible codes. The DXS transmitters are precoded at the factory to unique codes, so no field coding is required and can send a signal for up to 10 seconds per activation.
  
  The DXS-25 is supervised for low battery and sends hourly status reports. Some receivers are able to use these signals, others are not. Receivers must be programmed to the transmitter code before system testing and operation. Refer to the receiver's instructions for details on operation and programming.
  
  Each DXS-25 is powered by two self-contained type 2032 3-volt lithium batteries (included). When the batteries voltage gets low, a low battery report is sent with any alarm or status report to notify the receiver. The red LED will blink when the transmitter is activated with low batteries.
  
  A removable pocket clip and belt clip are provided for each transmitter. Either can be attached to the back of the transmitter allowing the unit to be clipped to shirt pocket or slid onto a belt.
  
  
  • Complete RF supervision
  • Alarm, supervisory, and low battery transmissions
  • Unique "Extra" top button
  • High visibility operate LED
  • Two type 2032 lithium batteries supplied
  • Pocket and belt clip supplied
  • DXS format
  Specifications
  • Dimensions: 1.6 in W x 4.2 in H x 0.8 in D (41 x 107 x 20 mm)
  • Power: Two 3V DL-2032 lithium batteries (supplied)
  • Current Consumption:
    Standby: 1 ľA
    Alarm: 8 mA average while transmitting
  • Battery Life: Five years typical
  • Measured Range: 1,500 feet minimum, open air (four quadrant test into DXSR-1504)
  • Channels: 8 channels - all individual buttons on the front of the transmitter (4 channels), plus top and then any front button (4 additional channels)
  • Operating Frequency: 315 MHz

  Compatibles by Linear

  • Linear Receiver 4-Channel Solid State Relay DXSR-1504
  • Linear Receiver 8-Channel Solid State Relay DXSR-1508
  • Linear Receiver DXR-701 1 channel
  • Linear Receiver DXR-702 2 channel
  • Linear Security Panel DUAL-824