EMX LP D-TEK Low Power Loop Detector

EMX LP D-TEK vehicle loop detector

The LP-DTEK's low 9 mA current draw make it ideal for solar applications and gate or door operators that require many accessories drawing from the same power supply. The lower current requirement means smaller solar panels are needed reducing costs.

• LP D-TEK is a 12-24 AC/DC Volt Vehicle Loop Detector
• First LOW POWER detector to operate both 12 and 24 AC/DC
• Only 9mA current draw with standby and detect modes "Fail Safe" included
• Loop isolation transformer
• Loop conditioner built in
• Aluminum RF shield housing
• Surge protection, Loop diagnostics, Frequency counter, Gold plated control contacts, 2 Relays
• Ideal for solar power applications

  TECHNICAL INFORMATION

• Power 12 and 24 Volts AC/DC
• Current Consumption 9 mA
• Operating Temperature -40o F to + 180o F
• Surge Protection Zener Diode /MOV
• Output relays (2) 1Amp 30 VDC
• Loop input Transformer Isolated
• Loop Inductance range 20 2000 uH
• Q-factor of 5 or higher
• Tuning Automatic on reset or power up
• Tracking Automatic for environmental changes
• Size Height 3.25" (83mm)
• Width 2.56" (40mm)
• Length 3.65" (90mm)
• Housing Extruded Anodized Aluminum
• Connector 86CP11 11 pin male
• Indicators (LED) Power, frequency, loop fail, detect, extend output

  Controls

• SENSITIVITY, PULSE ON ENTER, PULSE ON EXIT, 4 MINUTE LIMIT, INFINITE PRESENCE, SECOND PRESENCE RELAY, FREQUENCY, FAIL SAFE / FAIL SECURE, FILTER, AUTOMATIC SENSITIVITY BOOST, 3, 6, 9 SECOND EXTEND DETECT OUTPUT

Optional Accessories by EMX

• EMX HAR-11 Loop Detector Harness
• EMX LD-11B DIN Rail 11 Pin Mountable Socket Base